Cut six rectangular pieces of wood on the scroll saw. filigree brass charms. Make two of them sized 6 inches by 10 (for the bottom and top), two sized 10 inches by 2 inches and two pieces sized 6 inches by 2 inches (for the sides of the box).

Wood glue the short pieces to the edges of one of the larger rectangles to form a box with an open top, lining up the side pieces with the edges of the same lengths on the bottom piece. Glue the side pieces to the outside edges of the bottom piece so that the side pieces overlap and cover the bottom when viewed from the sides. Use masking tape to secure the pieces until the glue dries.

Attach the lid using hinges. Lay the box lid over the top of the open box, then lay each hinge so that it folds over corner formed by the box top and the box on one side. lampwork glass beads. Position each hinge 1/2 inch in from the outside edge. Fasten the hinges with the small screwdriver using the screws they came with.

Screw the clasp in place. Attach the eye piece to the front of the jewelry box, positioning it in the middle of the front panel and about 1/8 inch from the edge. Connect the upper hook piece of the clasp to the mounted bottom piece, then see where it lies on the lid while connected. Mark this point with a pencil, then remove the hook piece from the eye piece in order to screw it in place on the lid.

Sand the wood by hand with a medium-grain sand paper. Pay special attention to the inside of the box, especially the corners and any rough spots that might be hard on jewelry. jewelry chains. If necessary, give these areas a second sanding with a finer grain of sandpaper to make them extra smooth.

Stain the wood according to the instructions on the can of stain.

Varnish the wood according to the manufacturer's instructions.

Add a mirror to the inside of the lid using quick-set epoxy. Hold the mirror in place until the epoxy sets.

Select the appropriate size of crimp bead and crimping tool for your project. The size of crimp bead you select will depend on the thickness of the bead-threading jewelry wire you are using. Different crimping tools are designed to fit different sizes of crimp beads.
Take a crimp bead and slide it on to one end of the jewelry beading wire and then add a jump ring. glue in cabochon settings pendants. Take the end of the wire and string it back through the crimp bead.
Move the crimp bead up to meet the jump ring so that it fits snugly together, but is not so tight that the jump ring can't move.
Place the crimp bead that is on the beading wire into the first station, or notch, of the crimping tool. resin Eiffel tower pendants. The first station is the notch which is farthest from the tip of the crimping tool and has a dimple in its center.
Use your fingers to separate the beading wires so that they lie on each side of the crimp bead.
Squeeze the crimping tool so that the dimple in the center of the first station comes down on top of the crimp bead between the two strands of beading wire so that the strands are on opposite sides of the crimp bead. raw brass filigree charms. The crimp bead should now be in a "u" shape.
Move the u-shaped crimp bead to the second station of the crimping tool, which is closest to the tip of the pliers, and squeeze the crimp tool together. The two sides of "u" should fold together.
Begin stringing your beads and other jewelry-designing elements onto your beading wire. Once you have completed your strand of beads, repeat the above steps to secure a second crimp bead to the other end of the beading wire. China Beads Wholesale. Place the second crimp bead as close to the strung beads as you can, leaving only enough slack in the wire so that the beads can move slightly, but not appear loose.
Trim any excess wire from the ends of the crimp beads and secure whatever jewelry fastening device you choose to complete your project.